PDA

View Full Version : sr turbo studs/gaskets...



nonissan
05-25-2005, 10:32 AM
hello all,

where can i find the studs from the dump pipe to the turbo exhaust (should be 5 of them, no?)? also, will the gaskets for the turbo inlet/outlet from a 300zx turbo fit on the sr's stock t25? parts 14465-m and 16523-m on the courtesy page...

thx,

tim

http://www.courtesyparts.com/z32/oe_turbo-hw.html

Brad
05-25-2005, 02:02 PM
definetly the square exhaust inlet gasket will work

as for the exhaust outlet....the SR T25 uses a 5 bolt gasket, that looks like 4 so i dont think so

nonissan
05-25-2005, 02:39 PM
thx, i was speaking of the inlet tube that comes from the intake. it is a two bolt flange. and the outlet that goes to the hotpipe (not to the dump tube). it is three bolt. i refrenced the parts on the courtesy page. they look the same, same pattern, but i don't know if they are the same...

... right now though, the studs are giving me a bigger headache... the ones that go between the turbo and the dump. there are 5.

benevolent
05-26-2005, 06:19 AM
some of those are studs, others are bolts. can't remember wich are wich.but my local autozone sells both. the studs are behind the counter, you have to ask for them.i can't remember the size either.so take your turbo with you to make sure you get the right ones.

Nikeboy355
05-26-2005, 08:24 AM
this should help...

http://www.store.yahoo.com/phase2motorsports/oemsr20detpa.html

nonissan
05-26-2005, 09:51 AM
thx nike, but it doesn't. i know they sell the gaskets, but courtesy has the z32 ones for a few bucks. just wondering if they are the same......

anybody have any ideas on the studs though? what do people do when they upgrade their o2 housings about the studs? do they just reuse the old ones (doubt it..)

thx,

tim

cyanide
05-26-2005, 07:27 PM
this should help...

http://www.store.yahoo.com/phase2motorsports/oemsr20detpa.html


not relevant to the post, but every single part on that page is overpriced.