PDA

View Full Version : ARP Mains Review?



240Shorty
11-04-2005, 10:33 PM
Who's running ARP main studs and what are your thoughts? Are they needed or should u just run factory main bolts? I was just wondering b/c not to many ppl discuss what main studs they use in a rebuild. thanks

S14Redtop
11-05-2005, 12:10 PM
can't comment yet since I don't have mine..but they have been ordered. The only issue i have really heard of so far is that they might be too long for a couple of the holes and do not allow the secondary oilpan to lay flat against the block. therefore you might have to grind down the studs a bit. Besides that...i don't see whey you WOULDN"T use an upgraded part when you're doing the rebuild. I found the for 90$.

good luck
mark

Kjetil
11-06-2005, 04:27 AM
Yeah I'd say theyre needed, since the bottom bracket is one of the components that make the SR20 as strong as it is..

But, Yes, 2 of the bolts are too long, we had a guy in the Norwegian club crack his oilpan cause of them, so they have to be grinded down a bit.

http://forum.200sx-ogn.org/files/suc30004_164.jpg http://forum.200sx-ogn.org/files/suc30011.jpg http://forum.200sx-ogn.org/files/suc30018_180.jpg http://forum.200sx-ogn.org/files/suc30019.jpg http://forum.200sx-ogn.org/files/suc30020.jpg http://forum.200sx-ogn.org/files/suc30025_558.jpg http://forum.200sx-ogn.org/files/suc30021.jpg http://forum.200sx-ogn.org/files/1__3_.jpg http://forum.200sx-ogn.org/files/1__4_.jpg http://forum.200sx-ogn.org/files/1__5_.jpg http://forum.200sx-ogn.org/files/1_171.jpg

BlazedGlory
11-06-2005, 07:04 PM
hey man thanks a lot for those pictures and everything. I purchased the main studs as well, but I wasn't sure how I should end up checking them when I do the rebuild. Those pictues showed me exactly what to look for!

Kjetil
11-11-2005, 12:24 PM
No problem http://forums.freshalloy.com/images/graemlins/wink.gif