PDA

View Full Version : car wont start after 5 speed and sr20 swap



eliterit
02-10-2006, 07:49 PM
i had a running sr20 in my 91 240sx and decided to swap it into a different 91 240sx which is an auto.

i've swapped in everything including brake and clutch pedals.

the problem is when i turn the key to start the car, the starter will not kick over.

I researched this issue some and have found out to jump the blk/yellow wire with the white wire by the fusebox.

so i cut those wires and wired them together on the side that goes to the fusebox, and left the other pair alone that goes to the starter.

still no starter engagement.

did i wire up the starter bypass correctly?

There are two grey female plugs by the fusebox and one red one. i have the middle one which is grey plugged in via the plug coming from the tranny harness.

any help is greatly appreciated. thanks

OHH_
02-10-2006, 07:54 PM
http://www.heavythrottle.com/

just follow that

eliterit
02-10-2006, 09:33 PM
i have
its wired exaclty as shown on that site