PDA

View Full Version : FS: very clean S13 rolling chassis (the 300sx)



300sx
07-05-2006, 09:00 PM
I have decided that I do not have the funds nor time to mess with my S13 anymore so I am looking to sell it. This is the car that had a VG swap and shaved engine bay. Right now the car has the whole interior and wiring harness removed for cage install but only have the hoop tacked into place. Nothing on the car was cut/modified for use of the VG swap other than the front crossmember which has been swapped out for a fresh, unmodified one. The car looks the same in the pics minus motor and tranny. Also has brakes relocated to be hidden under the dash. I have all the wiring and interior pieces that go in the car. Here is what comes on the car.....
-91 S13 chassis, clean title approx 120k mi
-Tein Basic coilovers with pillow ball camber plates up front
-Attain front 5 lug conv. hubs
-300zx 4 piston front brakes
-SPL braided front brake lines
-91 300zx rear hubs
-H&R 20mm spacers and extended studs
-18x8f 18x9r no name wheels
-225f 245r tires in very good condition
-welded rear diff
-Kugel Komponents 90deg brake, reverse pivot clutch setup
-GM 7" booster and master cyl.
-Wilwood clutch master cyl.
-Chassis Eng. 6 point cage w/ swingout (incomplete install)
-Apexi cat back exhaust
I am looking to get around $4k for everything, will entertain offers/trades. Please contact me by email at T61civic@aol.com

http://uploadpixels.com/upload/1152147222_uploadpixels.com_s13fs3.JPG
http://uploadpixels.com/upload/1152147185_uploadpixels.com_s13fs2.JPG
http://uploadpixels.com/upload/1152147149_uploadpixels.com_s13fs1.JPG

cditch13
07-17-2006, 05:02 PM
Location???