PDA

View Full Version : optionalHow do I hook up the Boost Controller kit? for the PFC



Ricky240sx
03-17-2008, 11:46 PM
Heres a link to it but i'm trying to figure out if i pin the pink and black wire from the solenoid to the 5 plug of the MAP sensor...i'm running this on a SR20DET...its the middle plug in the center of the picture.http://paulr33.skylinesaustralia.com/docs/powerfc-faq/PFC_BCK.jpg

http://andrewmcc.com/powerfc-faq.htm#20

jetdriver
03-18-2008, 12:23 PM
I think most, if not all of the sr pfc's require you to use the factory wiring to the soleniod. If you have the correct boost control kit and your 5 pin plug only has 3 wires, then this is the case. The map sensor is the only thing used by the extra plug.

Mirage276
03-18-2008, 02:19 PM
The solenoid plugs into the stock wiring harness plug for the stock Boost Control Solenoid (s14 anyways) The map sensor plugs into the side of the PFC ECU, next to the plug for the commander.