PDA

View Full Version : Intake control Problem?



( . Y . )
03-26-2009, 03:15 AM
So I have a 5speed 1990 240sx and I did a sohc to dohc swap to the 96 s14 engine. I swapped everything to obd1. So I have everything hooked up and the engine starts but when it starts it revs up for about 10 sec staying in the rang of 3500-4500 rpms then just dies. So I start it again and it goes straight to around 4000rpms for 10 sec then dies, Over and over. I did cut all my emissions to the engine and I replaced my throttle body to a manual throttle body because the intake manifold I bought was off an automatic. Any Ideas why my engine is doing this???

Also I ran the self diagnostic on the Ecu and it has 2 codes.
1st: Slow blink, ... Fast blink
2nd: Slow blink, ... Fast blink, fast blink, fast blink

Any help would be huge. Thanks again

( . Y . )
03-26-2009, 04:03 AM
Ok so Code 1 is Camshaft Position sensor??? And code 2 is Coolant Circut.

Any help please?!?!?1