PDA

View Full Version : Blinker issue.



no_face
05-10-2002, 11:50 PM
Damn I feel dumb... but one of the silver screws that hold in the driver side blinker(below the head lights) will not come out. It just spins and if I unscrew the other one(comes out fine) and try to just pull the blinker/driving light out but no go. Any ideas.

97KAT
05-11-2002, 09:46 AM
Sounds like it is stripped, maybe try to unscrew the stripped screw while pulling gently on the light outward.

no_face
05-11-2002, 03:55 PM
Ya I tried that but it was a no go.. grr driving me nuts... thanks for the reply though 97 240

97KAT
05-12-2002, 04:33 AM
If you can get the head of the screw to come out a little, maybe you could dremel the head off. At least the light will come out and that will give you better access to that stubborn screw.

I dont know if you can get to the head though....good luck with it.

**DONOTDELETE**
05-12-2002, 08:23 PM
Originally posted by 1997 240 sx se:
Sounds like it is stripped, maybe try to unscrew the stripped screw while pulling gently on the light outward.<font size="2" face="Verdana, Arial[/img]If gentle doesn't work, pull harder on the light (as straight out as you can get). If you pull hard enough, the next thread WILL engage.