PDA

View Full Version : Help with getting Shift knob to fit



hssaini
08-11-2002, 11:05 PM
Hi, all i have the pdm racing obx new revised shifter. My greddy counter weight shift knob doesn't fit it. I get 4-5 turns and that's it. I want it to screw on all the way, so my shifter is less in length as well. It can go atleast another inch by screwing all the way up on the knob.

NISSAN is 1.25' thread, which i what i have.

wondering if 1.5 honda thread would work better?
Where can i go to have my shift knob redrilled/regroved to make fit the ****er.?????

Any help is appreciated

TIA
RINKU

Rcs476
08-11-2002, 11:27 PM
I had the same problem with mine. (Greddy/obx)

On mine, I just turned it pretty hard and it eventually went.

hssaini
08-11-2002, 11:38 PM
</font><blockquote><font class="small[/img]In reply to:</font><hr />
I had the same problem with mine. (Greddy/obx)

On mine, I just turned it pretty hard and it eventually went.


[/QUOTE]

Hi
2 ?'s
did you have the recently revised obx shifter? and not the first one they put out
did you have the counter weight shift knob (heavy one, 13.5 oz.) and not the other aluminum or light aluminum one?

Just making sure

RINKU

Rcs476
08-11-2002, 11:44 PM
I have the older OBX, I think it's starting the spinning crap.

As for the shift knob, it's pretty heavy, but I am not sure of counter weighted or not.
It was from www.wholehyper.com (http://www.wholehyper.com)
$35 if that helps any

hssaini
08-12-2002, 07:20 AM
Yah those are the aluminum type knobs.

The one i am talking about are the round heavy 13.5 oz shift knob from Greddy.
http://www.nipponpower.com/images/greddy83.jpg

hope this clarify things.

ANYONE?

RINKU