PDA

View Full Version : Length of S14 automatic drive shaft?



Zen S14
12-17-2002, 07:31 PM
I am trying to buy a carbon fiber drive shaft from ACPT. I was told that I need the measurements of the current shaft from Yoke center to Yoke center. Essentially the length of the shaft plus the middle bearing section.

Has anyone ever ordered this? If so what did you provide ACPT?

NOTE: I have the FSM information but it is not detailed enough. Also, I have an automatic, not stick and it is a S14 1995.

Thanks for any replies on this.

mdsdm
12-17-2002, 07:47 PM
You could measure it yourself with a tape measure. Driveshafts don't have to be dead on. No offense or anything, but why spend money on a cf driveshaft on an automatic? Just about anything else would be more cost effective.