PDA

View Full Version : Camber Problems



**DONOTDELETE**
03-03-2001, 10:16 AM
Hey guys, I have a 97 S14, and I am having some bad rear camber problems. I know my car has adjustable camber in the rear, but it does not adjust it enough to align the car properly. Do any of you guys have any solutions for this? Are there any companies out there that sell camber kits for this car? Thanks for any info guys.

03-03-2001, 11:46 AM
Well, there's one method of fixing the rear camber on the 240sx.org installs page that describes slotting the holes in the control arms. A better solution is to use offset camber bushings made by Whiteline. You can get them from www.fatman-racing.com. (http://www.fatman-racing.com.)

Asad

<BLOCKQUOTE><font size="1" face="Verdana, Arial[/img]quote:</font><HR>Originally posted by Boosted240:
Hey guys, I have a 97 S14, and I am having some bad rear camber problems. I know my car has adjustable camber in the rear, but it does not adjust it enough to align the car properly. Do any of you guys have any solutions for this? Are there any companies out there that sell camber kits for this car? Thanks for any info guys.<HR></BLOCKQUOTE>

03-03-2001, 03:09 PM
Do you have the bushings in stock, don?

Asad

<BLOCKQUOTE><font size="1" face="Verdana, Arial[/img]quote:</font><HR>Originally posted by PDM:
KCA347 are the Whiteline part numbers for the rear upper control arm offset bushings<HR></BLOCKQUOTE>

**DONOTDELETE**
03-03-2001, 07:15 PM
Thanks guys. How much are these bushings? I didn't see any prices on the webpage.

PDM
03-03-2001, 11:03 PM
Yup, 6 sets of bushings in stock at the moment.. $58 per set.

I've got more on order too.

don

PDM
03-04-2001, 12:11 AM
KCA347 are the Whiteline part numbers for the rear upper control arm offset bushings, that give you .75 degrees of camber correction. (they are the same bushing as the SPF1638K but with an offset hole in the center metal bushing.

Need more correction ?, then you purchase two KCA347 kits to correct up to 1.5 degrees of excess camber.

don
http://www.pdm-racing.com

ps, I WILL be be producing tubular rear arms in the future !! http://www.freshalloy.com/