PDA

View Full Version : SR can only boost minimum of .8-.9 bar?(11-13 psi)



LOwrestling2001
02-17-2003, 03:24 AM
For some reason, even with my boostcontroller off (profec B), my SR just started boosting .8-.9 bar instead of the usual .5 - .55 bar. What could be causing this? i checked all vacuum connections they seem to be fine, esp to the wastegate, what else could cause this, an actuator takin a crap on me? help!!!! thx

Society_Mike
02-18-2003, 01:17 AM
its possible the boost controller's solenoid is hanging up or not going back to normal when turned off.
Or you have a modified or aftermarket actuator.

LOwrestling2001
02-18-2003, 02:22 AM
oops nevermind found it, wasn't actuator or BC...previously when i tested the second EBC setup where the vac line to the ebc was T'eed off the compressor housing...and when ir everted to Teeing off the intake mani, i used a vacuum cap over the T by the compressor housing, which got blown off when i turned boost up to like .8-.9 bar...basically putting a hole in the system, but got that fixed no biggy.