PDA

View Full Version : One more question on pistons???



StealthmodeS14
05-17-2001, 01:23 AM
Hey guys, after getting my new pistons and rods for my Ka, exactly how are they installed? My friend asked me if they were pressed on. I was not aware that there was different ways they were installed. I'd like to do the work myself but I think the job is for somenody proffesional. can you help me out?

**DONOTDELETE**
05-17-2001, 04:52 PM
Hey,
I'm with Racetech USA in Orlando. If you need someone to build the engine, let me know. I've built quite a few Nissan engine ranging from KAs, SRs, CAs, RBs, and VGs.

Mark

matt240sx
05-17-2001, 06:42 PM
the pistons are floating pistons not pressed in. They have a snap clip holding them in.
Matt
HMP Motorsports

StealthmodeS14
05-21-2001, 10:20 AM
Hey Mizark,

How much would I be lookin at for you to install new rods, pistons, bearings, and the like. I'm avoiding a complete engine rebuild, I just want to strengthen the motor with lower comp. pistons to handle roughly 300~325 hp at the wheels.