PDA

View Full Version : CEL after swapping transmission, solutions?



ninety_six
05-15-2004, 01:45 PM
okay, a while ago i put an s13 tranny in my obd2 s14 and as most of yall know, the obd2 trannys have the crankshaft position sensor on the top of the bellhousing while s13s dont have this. So when i got it all in i just disconnected the sensor and of course i have a CEL now, what could i do to make this go away besides break the light? i guess i could always take the tranny out and swap the bellhousing from my old tranny, would that even work? but i wanna avoid takin the tranny out again cause this'll be like the 10th time ive done it and its startin to get old lol...

Thanks guys

RDM_II
05-15-2004, 11:01 PM
A) swap bellhousing
B) drill out existing bellhousing
C) remove CEL bulb
D) ignore it