- Is anyone using stock RB intake manifold?
- welded diff. broke......
- autometer tach install on sr20det s13
- hks actuator questions...yes i searched already
- greddy oil pan
- Turbo/Manifold Noise
- Factory service manuals, is there a difference...
- s14 problems with reving.
- Lining up the strut mount
- timing on power fc
- Z32 MAFS + 3" Piping
- Turbo + BMC
- 300ZX wheels on a S13
- I did another sr compression test. help me guys!!
- Strange front end vibration when LSD engages
- REVIEW: GP Sports SpecD Exas for S13 | (pics)
- Shop manuals
- does the techtom MDM 100N work with your SRconver?
- Having trouble lining up KA24de cams at TDC
- H&R springs, KYB AGX anyone have, thoughts?
- Sr20det advice
- 5Zigen FN01R-Cs on an S13...
- Best KA24DET Oil Catch Can Install
- for canadians near toronto..
- extended reach plugs....anyone??
- KA-T Setup question!
- Z32 caliper rebuild longevity
- Brake Pads for Zinc Plated Rotors?
- Factory S14DET Boost Pressure Sensor
- Factory S14DET Boost Pressure Sensor
- afc question
- meziere electric water pump kit for sr20
- JWT says don't use a S-AFC or HKS AFR
- GP Sports Susp. Question???
- Broken CAS cover. What are my options.
- Pics of 91-94 PS lines please.
- How much better is a copper rad than aluminum.
- loose flywheel
- Turbo Exhaust Outlet Flange for sr20det...
- H4 slimline fog
- Turbo spiking
- Has any been able to find this part (brace)?
- re: act 6 puck race clutch noise
- Compressor Map Overlays?
- KA-T Turbo Preperation
- oil turbo problem
- S13 det UR pullys!
- 19 hours of nissan
- Anyone ever install new set of pistons/rods/themse
- Lets see your Gauges!!!!!
- help with vac lines
- turbo oil seals
- snap the thread on the oil filter plate.. help
- SR Lines Turbo/Vac
- GREX Forged Pistons > Arias Pistons????
- My upcoming setup...
- Dual Flex a Lite Installation
- the White Bunny is going DOWN
- Nissan shoot-out in texas!
- S14 calipers on a S13 will they work and fit.
- 300zx rear brake questions
- Reisitor pack wiring sr20det redtop
- Unorthodox pully set for use in KA+T set-up????
- SR20 Apperant Timing Problem, Mysterious!
- Short Video: Me at HKS Drag Meet Okinawa Japan
- three part question
- Accusump or not?
- What should my Fuel Pressure be on my sr?
- Subframe bushing removal
- Installing FMIC ?
- S14 ECU Identification
- Question about turbochargers
- j30 axle swap (help needed)
- Defi Link Display
- post pic of your SR hot pipe!!!
- S13-->300ZX SS lines questions
- Replacing Cam Shims???
- KA-T Intercooler :: GReddy
- ACT Clutch Break-In...
- ? about wire from stock air box
- worth the money, time, effort etc?
- Are 300zx injectors the same as sr20det injectors? *DELETED*
- What parts can i use from a non turbo 300zx?
- Neutral suspension setup
- KA24DE Distributor Question ???
- QUICK HELP ME GET MY TRANNY OUT
- Power FC Part Number Differences
- check out this quad throttle body set up.
- s13 sohc ka in a 4x4 nissan truck ?
- Removing the cam sprockets.....argghh!
- Which is the Tach Signal wire on the cluster....
- sr problems - maf.idle....
- ka24e compression
- Post RB powered pics
- S-AFC Tunning
- My SR20DET 1/4 mile times *DELETED*
- GP Sports exhaust installed (pics)
- easy painless turbogasket replacement.
- VRT Mike....is this you?
- I can't get my tranny in.
- kinda dumb question
- Boost Limits on Ka-t
- problems starting & MAF problems... PLS HELP!
- Interesting Emissions info
- UPDATED PICS: My paint job is coming along well...
- *SR,GTi-R turbo,Q45MAF DYNO RESULTS need anylizing
- Having Fun With the FSM
- J30 VLSD Problem
- For those with Pillow mounts on strut/spring
- streetimports.com good or bad?
- msd ignition question
- Who has Q45 Brakes?
- What effects timing at idle?
- apexi multichecker
- Polyurethane bushings
- 25Mb video from HKS Drag Meet in Okinawa, Japan
- differences between 95 and 91 seat rails?
- S14, S15 or gti-r turbo is what i have?
- Alex (mav1178): Where's my dinner?
- Car hard to start, shaky and engine cuts off
- SR Cruise Control, possible?
- Random grey smoke on idle.... (updated)
- Any interest in a dash pod for the s13?
- Whiteline REAR sway bar endlinks vs stock endlink
- very high EGT's ....
- Greddy Oil Pan
- Hair Line crack in Turbo Manifold
- Sr20det Injector ???
- Engine Management for SR redtop?
- Ebay T28 hybrid???
- FLT-A2 setup questions.
- CA18DET in 14
- ATS LSD review and semi-writeup
- exhaustmanifold=>turbo leak ?
- Confused:: "Sticky" info does not make sense...?
- KA Timing Chains changed now no compression...
- question about moving heat controls
- Nismo SSS is here
- Some more pics
- RB25 swap using r33 crossmember.
- Whiteline bars work perfectly fine!!!
- Just finished SOHC to DOHC swap on my 90
- NE-1 have pics of Q45Brakes??
- Engine torque damper
- rpm and speed cut in SR20DET
- feul problem on my sohc to dohc swap
- A/C control question???
- Car idles for a second ... then dies ...
- Bad hubs or bushings?
- Flywheel torque specs
- Flywheel torque spec debate
- Finally... My Dyno Results
- New 1/4 times..
- miss firing and bogging like hell
- Problem with knock sensor?
- Fast Boost Cam Question please help
- GT2835R dyno results
- H&R Springs Install Question
- LSD Questions
- renamed: Haltech E6K instalation, sr20det s13
- S13 5zigen Typhoons Question
- What should I be expecting?
- please help, i'm out of ideas
- overspray
- Last step for my turbo project
- White Bunny loses a tranny mount!
- How not to setup a S14 for drifting!
- JIC Magic Type 1 exhaust
- S14 SR20DET Piston Rings Blown After 2000 miles
- SR20 swap problems AC/PS
- Temporary elevated idle after DOHC swap
- ARC super intake chamber? what the...
- Possibly new info about using Z32 Master Cylinder?
- Anyone got any settings for SAFC w/ KA-T and JWT
- has anyone installed a HKS type S S-13 FMIC
- Where to find heavier Springs for TiAL wastegate
- Technical Guru opinions
- Motorsports 275 degree cam set
- R33 LSD in a JDM S13 Q's ??
- wheel spacers...rear 300zx brakes with forged j30
- What's wrong with my SR- fuel/oil in catchcan...
- 12V source
- SR power steering lines?
- Walbro 255 fuel pump to big for stock Sr20det??
- shifter popped out of gear????
- S14 Wiring Questions
- S-AFC Vs. S-AFR
- Reputable L.S.D. installer in norcal?
- which is better on an SR? CAS or Distributor?
- light clutch pedal feel. alot of play in pedal
- howto - gaskets on manifold and turbo
- Nsport turbo kit
- help will it run?
- Greddy oil sender is NPT..
- DOING INSTALL NOW HELP!!!! SR auto-5spd ???'s!!!!!
- AGX's for s14's. Impressions? Reviews???
- SOLVED, how to bypass rear stock amp? *edit
- conversion
- lsd install question
- Replacing Piston Rings
- Mounting RX7 FD Seats into 180sx - Seat Rail Issue
- Rotora Big Brake Kit Review~~
- RB Info
- Top Mount Intercooler
- Insane exhaust leak
- i hit a deer, wtf, please help
- profec B spec VS profec B spec-II
- Will a GTI-R ECU work on a S13 Redtop?
- HKS SR20DET Cams...
- Nissdata ?
- 5 lug conversion and 300zx brakes all around done!
- stumped... need major help!
- Dynoed 282RWHP to with 50lbs injectors Why??????
- What's stuff worth???
- Not running tranny exhaust mount...
- 2nd attemp at drag race
- Who makes the best carbon fiber hood (S14a)???
- Valve cover torque specs
- Upper oil pan prob...
- 740cc injectors
- Update: Lota junk on the pistons
- My Drift Day Car Pics and summary
- KA26DE, KA28DE, is this possible???????
- idle problems
- Pilot bushing uninstall reinstall ?
- LSD, 5Lug, ZBrakes, Swap pics and tutorial. S13
- Are AGX 'progressive' shocks?
- timing marks
- HKS Clutch kit on almost stock sr20
- Car won't start anymore
- need help with some part numbers for kouki s14
- turbo KA question.. injectors ??
- Problem with fuel
- Car over heating, but fan and coolant are fine
- viscous lsd
- rear main seal
- Running rich
- Secret Services 180sx Preview video (short)
- SR is in the car!!!
- Wiring question on sr20 in an s13..
- What Radiator to use for S13 SR into S14 chassis?
- Shock/spring install -- new parts needed
- Car down, Need MAJOR Help......**LONG**
- Won't speed up when I throttle up
- Secondary O2 bung size on S14? Doh broke a stud!
- S15 Front End Conversion for $799?
- steering
- Rev limiter not working as it should
- Master Cylinder Swap/Upgrade?
- wondering about rear ends