Motordyne MRev 350Z Power Upgrade Pacakge

[noelsaw]

Need more power from your 350Z? Check out this unorthodox extraction method...

Read here:
http://www.freshalloy.com/site/cars/nissan/2005/z/motordyne/

[wperdigon]

cool - I like how they did a throttle body bypass on it - though I wonder how this will affect it in the winter when you would want warm coolant passing by

[Hydrazine]

cool - I like how they did a throttle body bypass on it - though I wonder how this will affect it in the winter when you would want warm coolant passing by



You can certaintly use the Copper Iso Thermal version if you prefer. Its a polarized heater consisting of a copper plate that gets hot on one side and is thermally insulated on the other.

It will heat the throttle body to prevent freezing or ice formation even if you are driving through Buffalo NY in the middle of a winter snow storm. It will also allow your plenum to run as cool as equilibrium will allow it.


Basically, if you live in places like So. Cal., Florida, Tx or Hi, you don't require the Copper. Its more of a convience factor.

If you live in areas wher it snows or gets really cold, you should get the Copper Iso Thermal. In addition to being more convient, it will allow you to take full advantage of the dense, cold air environment.

Tony

[NissanTechSeR]

I'm sure a new set of cams would more than cure the top end loss http://forums.freshalloy.com/images/graemlins/grin.gif

[AndyPerformance]

Unfortuantely there are no cams available for the Rev Up motor. The Rev Up motor already has better cams than the 287HP motor and due to the variable valave timing on the exhaust side of the Rev Up motor, all the aftermarket cams available for the Z will not work. The intake side would but not the exhaust side.

[AndyPerformance]

For the month of Decemeber, if you mention you are a FA member in the comment section you will get 8% off the MREV package.

[wperdigon]

Make sure to post this in sponser specials -

[idrive]

wow, i like the results, great job guys!